Some of the major concerns for those looking to protect their boats with a marine extended warranty are the potentially pricey components of the Outboard Engine. With our boat warranties these engines would be covered, when applicable, leaving you with the peace of mind that if your outboard engine suffers a mechanical breakdown, you will only be responsible for one low deductible while the warranty picks up the rest of the repair bill! The following parts of your outboard engine are examples of what would be covered under this marine extended warranty:
Pistons, piston rings and pins, main and rod bearings, crankshaft, connecting rods, camshaft, camshaft bearings, valve, valve springs, guides and seats, reeds and reed blocks. Timing chain, gears and/or belts. Seals and gaskets of a covered component if defective. Engine head(s), engine block and/or cylinder barrels.
Internally lubricated parts contained within the gear case. seals and gaskets of a covered component if defective.
Internally lubricated parts contained within the pump housing. Seals and gaskets of a covered component if defective.
Fuel delivery pump (mechanical/diaphragm), carburetor body, air box (silencer), electric choke solenoid (enrichener).
Alternator/stator, voltage regulator/rectifier, engine mounted terminal blocks, engine mounted wiring harness, starter motor, starter armature, starter field windings, starter magnets, brush holder and brushes, end caps and bushings, starter drive, starter solenoid.
Power pack/switch box, amplifier, ignition high output coil, ignition trigger coil, spark plug wires.
Power trim motor, power tilter motor, power trim cylinders, including cylinder rams, cylinder seals, cylinder mounts and pivots, power trim motor actuator solenoids, power trim wiring harness, power trim master control switches, reverse lock valve, manual trim cylinder, manual trim cable and control valve.
Shift and throttle control box parts to include: cams, eccentrics, shafts, pivots, bushings, housing, control arms/levers and knobs, shift control cable, throttle control cable, ignition switch
Control helm assembly, control rack and yoke assembly, power steering pump, power steering cylinder, steering wheel, steering wheel mounting hub.
Hydraulic steering head, hydraulic steering lines, hydraulic steering cylinder, hydraulic steering flow valves, steering yoke.
Oil injection pump, oil pump drive gear, oil pump drive shaft, oil tank, oil tank cap, oil level sensors, oil level warning horns and lights, oil injection lines, oil injection check valves, oil injection metering system.
Electric fuel delivery pumps, fuel injectors, fuel distributors, ecu module, throttle position sensor, manifold air temperature sender, idle speed control, mass air flow sensor, detonation/knock sensor, ignition pick-up sensor.
Get your outboard engine covered before a breakdown occurs! A knowledgeable marine warranty specialist will be able to draw up a no-strings-attached warranty quote for you today!